The difference between aluminum bar and aluminum veneer

Introduction: Aluminium strips are made from aluminium alloy plates. Aluminium strips are classified and available in a variety of sizes, including H type plug-in type, C type, G type, B type, R type high spell, S type low spell and patented product arc strip pinch.

The difference between aluminum bar and aluminum veneer

Aluminium strip ceilings are made of aluminum alloy plates. Aluminium strips are classified and available in a variety of sizes, including H type plug-in type, C type, G type, B type, R type high spell, S type low spell and patented product arc strip pinch.

Aluminum Bar specifications:

The width of the aluminum bar is 50mm, 100mm, 150mm, 200mm, 300mm, 400mm.

The thickness of the Aluminum Strip is usually 0.5?mm-1.2mm.

The strip buckle plate adopts continuous roll forming, and the conventional maximum length dimension is 8000mm.

The surface coating is generally powder electrostatic or polyester paint spraying, roller coating, wood grain, brushed surface treatment can also be selected.

Aluminum veneer is made of high-quality alloy rust-proof Aluminum Sheet, which is processed in the factory by sheet metal processing, surface chemical treatment, and spray painting, baking and curing. Aluminium veneers are suspended from the light weight of the retaining wall on the outside of the main structure of the building to form a large-area continuous wall surface, which is called the aluminum veneer curtain wall.

The thickness of aluminum veneers for outdoor use is generally 2.5mm, 3mm; for low-rise floors and podiums, 2.0mm thickness can be selected, and for indoor walls and ceilings, the thinnest 1.0mm or 1.5mm can be selected.

Width direction: Usually, the aluminum sheet raw material of aluminum plate manufacturers is rolled into the plant, and the common width varies from plant to plant, and is mostly 1.5m to 2.4m and wider. The width of the aluminum veneer should be given priority to 1.5m and below, because this specification has the lowest price and the shortest lead time. Excessive width of the plate not only increases the price, but also increases its deformability as the size increases, which easily results in deformation of the workpiece surface and instability after installation.

Length direction: Since the length of general bending equipment is 6m, it is not recommended to process aluminum single-piece workpieces with a length of more than 6m.

6xxx Series Aluminum Sheet

Perforated Aluminum Sheet,Decorative Aluminum Sheet,Perforated Aluminum Sheet,Brushed Aluminum Sheets

Jinan Xinhai Aluminum Industry Co., LTD. , https://www.jnxinhai-alu.com